Where On The Windshield Do You Put The Ipass Detector

Windshield Mount

1. Clean and dry the inside of your windshield around the rearview mirror.
2. Identify the front face of your E-ZPass tag (it will have the label with the Maine Turnpike Logo and the tag serial number). This side faces the interior of the vehicle with the arrows on the tag pointing toward the roof.
3. Locate the correct position for the tag — the upper eye portion of your windshield behind the rearview mirror, at to the lowest degree 1 inch to the right of the mirror and at least one inch beneath the top edge of the windshield. If your vehicle has tinted drinking glass, make sure the device is at least ane inch below the tinted section of glass.
4. There are four adhesive strips: two are permanently mounted to the tag, and 2 are for mounting to the windshield. Without removing the second fix of adhesive strips from the tag, carefully remove the protective backing from the mounting strips on the rear of the tag.
5. Turn the tag right side up facing you. Place the tag in the correct position and press firmly confronting the glass for 15 seconds to achieve a good bail.
6. Your E-ZPass tag may be removed by gently lifting one corner of the tag to divide the agglutinative strips.
7. Please notation: Do non try to remove the mounting strips from your windshield and reuse them. An extra ready of mounting strips was provided with your E-ZPass order. You may order boosted mounting strips by calling E-ZPass Customer Service at 1-888-MTA-PASS (1-888-682-7277), Mon through Friday, 8:00 AM to six:00 PM

License Plate Mount

1. Identify the apartment side of your E-ZPass tag. It volition have the sticker with the Maine Turnpike Logo. This side should face in to your vehicle.
2. Fasten your E-ZPass tag to the front license plate using the existing tiptop mounting bolts and the knock-out holes at the lesser of the Eastward-ZPass tag, so you practice not cover the state name on your license plate. Tighten the bolts securely, but practice not over tighten.
3. Delight note: Your E-ZPass license plate tag should exist attached to the middle of the forepart bumper, fifty-fifty if your license plate is in a different location.

Roof Mount

1. Locate the correct installation position for your E-ZPass roof-mount tag. It should be on the roof of the vehicle, on the centerline a minimum of 3" from the forepart of the cab roof.

   Do not install the tag:

   • inside ii' of any radio transmitting antennas;
   • on the sloping surface of a cab or roof — the bottom of the tag assembly must exist parallel to the route;
   • backside horns, lights or other metal objects;
   • inside ane' of any trailers or other metal objects.
   A plastic or fiberglass air dam or spoiler may comprehend the E-ZPass tag, provided the cover does not have any metal paint or metal foil decals on information technology.
2. Bolt the Eastward-ZPass tag to the cab roof deeply.

Where On The Windshield Do You Put The Ipass Detector,

Source: https://ezpassmaineturnpike.com/EZPass/Page.do?id=instructions

Posted by: vezinafroneam.blogspot.com

Share this post